Yep. I agree with all the above, basically, except for:
Quote:
|
3.If these are all ok AND all of the bolts are equally snug on the torsion units then tighten the big bolts only a little bit (maybe an eighth of a turn) on all 4 when up, test.
|
In my case, the torsion bars at the middle of my TM came to me with those bolts more extended than the bolts that were at the ends of the TM. I first tried tightening all bolts to be almost equal (meaning that I tightened the middle bolts to match the end bolts) and found that I could then barely move the shells. I then returned the bolts to where I started
and from there I then adjusted until I felt I had the best lift and close.
Bottom line advice from me is if you just need a slight betterance, and there are major differences among some of the bolts, then start from where they are currently with slight adjustments.