Quote:
Originally Posted by commodor47
My thought is to use just the bottom half of a french cleat mounted on the wall. Then you can slide the lower part of the wall plate down into the cleat. That way the bottom half of the wall plate would be securely attached allowing the upper part to be tilted into place and secured with the two screws.
|
Oh, that is simpler than what I was imagining. I could secure the lower cleat with VHB tape and I could use the existing part without reprinting it (just print the cleat part). I'll try it.
__________________
2007 3124KB, 40 gallon water tank, weight distributing hitch
2006 Toyota Sequoia SR5 4WD
|