Quote:
Originally Posted by FlyboyTR
I have never used any type of adhesive/sealant on standard grease seals. If the seal is the correct size and properly installed, it should never move. I just wipe excess grease off the hub and install the seal. I do wipe a light coat of grease on the seal lips. This keeps them from sticking on initial install and use.
|
Sounds like most folks don’t use the Permatex, even though Dexter says to apply it unless the seals have a rubber coating. I have decided to replace the entire drum/hub assembly, & everything is already assembled. I’ll revisit the question when it comes time to recheck the bearings.