Very nice installation, and a good solution to the issue.
I would also like to see a non-welded mod that would lower the parked position of the carrier about 1/2" toward the ground. With a fully aired up spare, mine is so tight that it is VERY difficult to raise the carrier enough to engage the support bracket on the curb side. I end up having to pry the carrier upward with a big screwdriver, and then push it in with my feet.
I suspect that lowering either end of the assembly by 1/2" would be sufficient. But I don't see an easy way to accomplish it without getting a welder involved. Ideas?
Bill
|