Good add, Gonzo. Thanks for taking the time to do it - it was needed. Let me suggest a couple changes.
In para 3,
Quote:
Now turn on switch on front of cabinet (switch is usually red and mounted on left side). Switch should illuminate when heating.
|
The switch actually illuminates while the controller is in the process of igniting the burner. When the burner ignites, the light goes out. I call it the "trying to light" light.
In para 4,
Quote:
to run furnace, move thermostat to a setpoint greater than ambient temperature. Fan will come on. After delay (I think 5 minutes) the igniter will be heard.
|
In my TM, at least, the delay is more like 10-15 seconds. During this time, the controller is using a "sail switch" to confirm that the fan is up to speed. It takes the fan a few seconds to move the sail, but 5 minutes would be tough to swallow.
Just FYI ...
Bill