[commodor47]

Here are a few more suggestions that may help to ease the movement of the slide.

Spray a little silicone onto a paper towel and carefully wipe down all bag seals that contact any wall. It is a tight fit but I have been successful at getting my fingers between most of the bag seals that contact any walls.

I have also had good luck spraying the rollers with silicone. Go ahead and use silicone spray on any pivot points along the swing arms.

Lastly, spray silicone on the track where the supporting swing arm pins move as you open and close the slide.

This should make opening and closing the slide much easier. Repeat the process as needed.

Dick