Cabinets

[Casey Freswick]

Made drawers for cabinets. What type of slide did you recommend? My wife demands a full extension slide. So that may be somewhat problematic. Also my drawers fit tight, so it must be a undermount slide.

[Padgett]

Mine seem to be marine drawers, have to raise a bit then pull out so don't open on the road.

[Kidkraz]

Bill made some drawers for his TM, you should check his albums section he has the info posted there. They appear to be full pull outs from what I saw.

[Casey Freswick]

Brought back in pieces my partial slide pull outs to Menards, they refunded me with no problem. Local Cabinet shop gave me pointers and I purchased slides from them for the same price I found on-line but with great advice. Have 3 of 5 finished, but may redo first one. Hope to finish installing in a week or so. So what I can do today.

[Casey Freswick]

Finally finished the cabinets. Ultimately went with a high end full extension slide. Original measurements were too exact and rebuilt two drawers to give me some play. But all well that ends well. Had to move electrical lines in middle drawer. Difficult getting two slides made for side to fit on bottom but now everything slides easy. Also stained and varnished the drawers. Thanks for the help and suggestions.

[[email protected]]

I was going to have a friend build a hanging cabinet for my 2619 and wasn't sure the brackets would clear the folding sides. Also is there a best place to drill holes in the walls?
I plan to put a cabinet over the sink

[Larryjb]

I noticed that the bracket on the wall that holds the kitchen cabinet is the same as the bracket the table hooks into. The hook on the cabinet is the same as the close down hook on the side of the trailer.