Well found out the toilet is not hooked up , I really did not pay too much attention when I first looked at the TM. even if I had known I would have still bought it. I found the power wires to the switch cut off and the valve is at the rear of the toilet yes the dump pull lever is at the rear, and it is mounted on a piece of wood I guess to raise it off the floor more, the toilet was basically just sitting there. I removed the toilet ( picked it straight up ) very light so I guess there is nothing in it. but the gauge shows it is charged. So I turned the wood piece around where the handle faces the front. I am going to open up the switch area / motor/pump etc. I am guessing they had it screwed to the wood.
So if I take the slide valve off the wood and mount it directly to the toilet , is there enough room to get your hands under it to push the holding clips back under the nuts?
Also since it has been off before I took it off, is there a wax ring that needs to be replaced as in home toilet flanges? Plus I dont think the legs o the toilet actually hits the floor with this riser under it.....
Sorry for all the newbie questions
Magic 80 toilet issue
Threaded Mode
