Three Years Ownership of TrailManor: Some Observations

The rubber bumpers on my tongue and on the rear bumper supports are flattened out due to the shells riding on them. I should probably replace them, but even replacing them wouldn't stop the latches from coming undone I don't think. Another thing we're having trouble with is the square tubing that holds the shells in place when they're up. The lags that hold them won't stay tight enough so once you walk around in the trailer they all fall down to the position they travel in. I put Lock-Tite on them but that didn't work. I think I'll fill the holes with silicone and then run them back in. Any other suggestions?

Originally Posted by Freedom

Any other suggestions?

I talked to the factory about my loose lag bolt and they suggested that I either drill out the hole and glue in a dowel and then screw in the lag bolt back in, or that I try a slightly larger lag bolt. They suggested (several times during the conversation) that since the square aluminum corner latch fell down it indicated that the trailer was properly set up and was not putting any stress on the latch.