Quote:
Originally Posted by Wavery
I removed the curtain and all the trimmings from the inside. That exposed the opening to the inside and was able to run the wire up through the center roof molding ...
|
Do I understand that if I remove the rear window curtain and the trim, I will find access into the back wall, and the wires in the wall exposed or accessible? Hope so - I am still trying to figure a nice way to add backup lights to my 2020 2720QS - the factory did not add them.The backup light wire from the 7-pin Bargman goes as far as the refrig compartment, and dead ends there. I'm looking for a way to get them to the back wall and up into position. This could help.
My Plan B for this project is to run the backup light wire under the TM to the back bumper area, and mount backup lights on the bumper. It would be simple, it would work, but it wouldn't look great.
Bill