Quote:
Originally Posted by ZekenSpider
The magnet is strong enough to hold the shower head in position on any of the three walls through the shower curtain.
|
This was my thought also but in practice it didn't quite work. I used the heavier of two magnets that I purchased The Oxygenics is a fairly heavy showerhead compared to the original. With the shower curtain sandwiched between there isn't enough friction to keep the magnet in place. With the shower curtain being so smooth, the magnet would slide down or rotate around. It wouldn't fall off but it wouldn't stay put either. I have the metal strip centered where the 2 curtains meet and the showerhead comes through the split. The magnet is attached directly to the metal strip.
__________________
TV: 2002 Toyota Tundra Acess Cab, TRD, 4WD, LS, Tow Package.
Mods: 7-pin Connector, Tekonsha P3, Reese WDH, Milenco Grand Aeros, Leer cap, FS airbags, RVS backup cam & monitor, front hitch.
TM: 2008 2619, A/C, Swing Tongue, 40 gal Tank, Awning, Cabinet over sink, MW drawer.
Mods: Kumho 875 205/R14s, Shower curtain & Oxygenics, Sewer hose stow, Prop reg on top, (2) Trojan 27TMs w/1+2 switch, Marinco A/C plug, RVS backup cam, Honda EU2000i & companion w/extended run tank.
|