I have purchases a 3124 King 1998
I have severe wear marks on the side of the bottom 1/2 of the trailer. The top is not square. I have the trailer sitting on a concrete slab and leveled to with in a 1/8".
There is evidence that the top ½ of the door has been swung on due to the hinge being bent.
When the trailer is raised there is as much as 1.5” difference between the two sided.
You can lower and raise the trailer but you have to be very careful and push and pull to get it to go down correctly. When going down the road the trailer will unlatch itself. It appears that the top needs to be re-adjusted and square, need a little direction and experience. How much torque is left in the arms in the up position? Can you damage the shell by supporting it along the sides while raising and lowering the shell.
I have had no luck getting information from trail manor. At this time I plane on starting with a 1/2" gap at door and going around the trailer to level. Does this sound correct???
Does any one have any information on leveling the top of these trailers and the correct measurements? See the photos attached.
Thanks
Pat
See Photos
http://s275.photobucket.com/albums/j.../Trail%20manor