Pocket Stops Missing Bolt

[cpiznee]

I breaking loose from another thread. I've gotten awesome advice from the forum.

My front shell on the door side goes forward too far. After advice and research, I wanted to adjust the pocket stops. There are allot of old threads about pocket stops(with pics missing) but I couldn't find any on missing bolts. The bolt for the front and back shell (door side) is missing. I need to replace it.

Does anyone know if that bolt is holding something in place? In other words was it holding the rubber stop or is it held in place by something else?

How does adjusting the bolt adjust the travel of the shell?

How long is the bolt?

I'm trying to figure out if I can just buy a new bolt from Ace and screw it in. I'm guessing its not that simple.

I'm hesitant to take out the bolt and nut on the other side to use as an example. I'm afraid something may fall out of place behind the wall. Then I'll have 2 shells messed up. Any advice??