Disconnecting Carbon Monoxide Monitor
Hello all,
I put in a trailer battery disconnect switch and I noticed that when the battery was disconnected it caused my CO monitor to beep intermittently. When I unscrewed the unit from the wall it appeared that the monitor was not battery powered but powered from the two wires going in to it. See my attached pictures. My question is, when you look at the picture with the two wires, should I be able to pull on those wires and that will detach them. Thus disconnecting the monitor? It looked like that might be possible. But I was afraid to pull for fear that I might break it.
Thanks in advance to anyone who may have already crossed this bridge!
|
Threaded Mode
