Temp control on fridge works in DC mode

**ShrimpBurrito** · 11-21-2010, 10:05 PM

I have read in numerous places here that the temp control does not work while the fridge is in DC mode. Today, quite by accident, I think I have confirmed that is not the case.

I turned the fridge from gas to DC in preparation to leave camp, and then I checked the Link 10 battery monitor to make sure it was drawing its usual 9 amps. Much to my surprise, the Link 10 was measuring only about 0.2 amp draw from the battery. The temp control was only about half way up, so I turned it to max, during which time I heard a gentle click noise, and the Link 10 bumped up to a 9 amp draw. I turned the temp control back to where it was to confirm what had happened, and the Link 10 went back to 0.2A. Turned it back up, and it went up to 9A again.

So at least on my fridge, I'd say there is control in DC mode.

Dave

countrygirl · 11-22-2010, 07:07 AM

"Cool" info...thanks!

**Bill** · 11-22-2010, 10:44 AM

You have a Dometic refrig, model RM 2xxx, right? When we were going through this a few years back, I don't recall what we conclusded about the Dometic and DC operation. And a quick online check says it depends on the specific model.

I'm pretty sure that my Norcold does not work that way. But it is worth checking my Norcold, and not hard to do.

Bill

**ShrimpBurrito** · 11-22-2010, 10:45 AM

That's right, Bill. The model is Dometic RM2300.

Dave