TrailManor Owner's Forum  

Go Back   TrailManor Owner's Forum > TrailManor Technical Discussions > Electrical
Register FAQ Members List Calendar

Reply
 
Thread Tools Display Modes
Old 06-03-2024, 12:20 PM   #1
Kevinandvicki
Member
 
Join Date: May 2023
Posts: 21
Default Battery draining faster than charging

Hi all. I have a 2007 2720. I am plugged into a 30 amp at rv park. Prior to trip, I was plugged in at home. Battery was charging up to 3/4. Here at park, I am using the fan and lights. last night, the battery was down to almost zero. Lights were low and heater wouldn’t turned on. I turned off all lights and fans, and this morning, battery is currently charged up to half and hopefully rising. All AC outlets are working fine. The battery is an Interstate less than a year old. I rarely use the trailer unplugged. Any idea why my battery seems to be draining faster than it is charging.

Additional information. I removed the original fridge and installed a mini fridge freezer. 110. Also, removed the stove and installed a mini freezer. Also 110. Am I pulling too much power so there isn’t anything left for the battery?
Kevinandvicki is offline   Reply With Quote
Old 06-03-2024, 12:35 PM   #2
ShrimpBurrito
Site Sponsor
 
ShrimpBurrito's Avatar
 
Join Date: Jul 2006
Location: Sunny Beaches of Los Angeles
Posts: 3,279
Default

First of all, have you checked the water levels in your battery? If the water levels are below the plates, you can expect poor battery performance. If they need water, only use distilled water.

Second, when connected to shore power, the 12-volt TM appliances should all work fine regardless of the battery charge. In fact, they should work just fine without any battery at all. So if your water levels aren't the problem, I think I would just disconnect the battery, making sure to not let them touch each other, or anything else metal (especially the TM frame). You could just wrap some tape around them. Then go inside and test your 12-volt appliances. If that solved the problem, then your battery is suspect. If it doesn't, then I think I'd next be exploring the converter (which charges the battery, and also converts 120 volts AC to 12 volts DC for your 12-volt appliances.)

Dave
__________________
2000 2720SL & 2007 3124KB
2005 Toyota Sequoia
Twin Battle Born 12v 100Ah LiFePO4 (BBGC2) batteries, 300W solar on rear shell, Link 10, Lift kit, Maxxis 8008 225 75/R15 E tires
ShrimpBurrito is online now   Reply With Quote
Old 06-03-2024, 12:57 PM   #3
Bill
Site Team
 
Bill's Avatar
 
Join Date: Feb 2003
Location: The mountains of Scottsdale, AZ, and the beaches of Maine
Posts: 10,216
Default

Quote:
Originally Posted by Kevinandvicki View Post
Hi all. I have a 2007 2720. I am plugged into a 30 amp at rv park. Prior to trip, I was plugged in at home. Battery was charging up to 3/4.
Presumably you are judging the "3/4" level using the little lights on the sink apron? They are reasonably useless, so we don't get a lot of info from that, except that the battery had at least some charge.

Quote:
Here at park, all AC outlets are working fine.
This tells us that park power is good.

Quote:
I am using the fan and lights. Last night, the battery was down to almost zero.
This tells us that the battery charger is not charging the battery at any significant rate.

Quote:
Lights were low and heater wouldn’t turned on. I turned off all lights and fans, and this morning, battery is currently charged up to half and hopefully rising.
Again, "charged up to half" is judged by the little lights on the sink apron? Still, it sounds like the battery is getting some charge, but just a trickle.

Question - is the TM plugged into the tow vehicle during all this?

Question: is it possible that the pin on the break-away switch on the tongue has been pulled?

Question: Are the circuit breakers (3 or 4 big black things in the converter) all turned on? Be aware that you cannot judge them by eye. You must push each one to the OFF position, and then push it back to the ON position. Each push should be crisp, not mushy.

Quote:
Additional information. I removed the original fridge and installed a mini fridge freezer. 110. Also, removed the stove and installed a mini freezer. Also 110. Am I pulling too much power so there isn’t anything left for the battery?
If you are sure they were running on 110, those don't sound like big power consumers, though you might check their tags for "amps" or "watts". If they were inadvertently set to DC, that is a whole different story.

You may find that the battery charger in the converter is failing. We'll try to find some other cause - be hopeful. The converter has some fuses inside it that could cause this behavior, but they don't often fail.

Bill
__________________
2020 2720QS (aka 2720SL)
2014 Ford F-150 4WD 5.0L
Bill's Tech Stuff album
Bill is offline   Reply With Quote
Old 06-03-2024, 04:27 PM   #4
Kevinandvicki
Member
 
Join Date: May 2023
Posts: 21
Default

Dave. Water level is fine. Lights do no work when I disconnect the battery. When I put the volt meter on the battery, it is between 11.4 and 11.9 while plugged into shore power. Same when unplugged from shore power.
Attached Thumbnails
Click image for larger version

Name:	IMG_20240603_140841587.jpeg
Views:	823
Size:	5.30 MB
ID:	23260   Click image for larger version

Name:	IMG_20240603_140826368.jpeg
Views:	785
Size:	3.81 MB
ID:	23261  
Kevinandvicki is offline   Reply With Quote
Old 06-03-2024, 04:32 PM   #5
Kevinandvicki
Member
 
Join Date: May 2023
Posts: 21
Default

Bill. Not plugged into tow vehicle. Break away pin is still in place. All breakers inside are fine. Volt meter on battery shows between 11.4 and 11.9. Freezer and fridge are 110 only. No DC option.
Kevinandvicki is offline   Reply With Quote
Old 06-03-2024, 06:50 PM   #6
ShrimpBurrito
Site Sponsor
 
ShrimpBurrito's Avatar
 
Join Date: Jul 2006
Location: Sunny Beaches of Los Angeles
Posts: 3,279
Default

Hmmm....it seems to me the converter does not have any DC output for some reason. What does model is printed on the nameplate on the cabinet for the converter (the door you opened to check the circuit breakers)? MagneTek 6300 Q Series by chance?

I'm sure Bill will chime in with maybe other ideas, including how to further chase this one down.

Dave
__________________
2000 2720SL & 2007 3124KB
2005 Toyota Sequoia
Twin Battle Born 12v 100Ah LiFePO4 (BBGC2) batteries, 300W solar on rear shell, Link 10, Lift kit, Maxxis 8008 225 75/R15 E tires
ShrimpBurrito is online now   Reply With Quote
Old 06-03-2024, 07:03 PM   #7
Kevinandvicki
Member
 
Join Date: May 2023
Posts: 21
Default

Dave. It is a WFCO WF-8955. One test I did makes me think it is the converter fuse panel. Without the battery hooked up, the fuse panel is reading 1.2 from the AC lines. Not sure if that means the fuse panel is bad or the converter. Trying to find some troubleshooting videos.
Kevinandvicki is offline   Reply With Quote
Old 06-03-2024, 09:36 PM   #8
ShrimpBurrito
Site Sponsor
 
ShrimpBurrito's Avatar
 
Join Date: Jul 2006
Location: Sunny Beaches of Los Angeles
Posts: 3,279
Default

Quote:
Originally Posted by Kevinandvicki View Post
Without the battery hooked up, the fuse panel is reading 1.2 from the AC lines.
Can you expand on what do you mean by this? Is 1.2 referring to amps? Volts?

The fuse panel only protects DC circuits, so I'm just not sure what you're referring to.

When you're plugged in without the battery connected, what exactly is displaying 1.2?

Dave
__________________
2000 2720SL & 2007 3124KB
2005 Toyota Sequoia
Twin Battle Born 12v 100Ah LiFePO4 (BBGC2) batteries, 300W solar on rear shell, Link 10, Lift kit, Maxxis 8008 225 75/R15 E tires
ShrimpBurrito is online now   Reply With Quote
Old 06-03-2024, 09:44 PM   #9
Wavery
TrailManor Master
 
Wavery's Avatar
 
Join Date: Jan 2022
Location: San Diego, California
Posts: 2,942
Default

Quote:
Originally Posted by Kevinandvicki View Post
@Dave. Water level is fine. Lights do no work when I disconnect the battery. When I put the volt meter on the battery, it is between 11.4 and 11.9 while plugged into shore power. Same when unplugged from shore power.
Sounds like your converter's charger is either disconnected, the breaker is turned off or it's shot (common). When you are plugged into shore power, the voltage should read 13.8V minimum. That 13.8V should be coming directly from the converter's charger. If that's not happening, there's a problem with the converter.

Your 110V appliances have nothing to do with your converter's charger or your battery. That 110v is coming directly from your power cord to your converter's breakers. The fridge and freezer combined only draw about 10A maximum (if both compressors are running at the same time). Your service from the power cord is 30A.
__________________
TrailManor Elkmont
640W solar- 230AH LiFeP04 Battery
Wavery is online now   Reply With Quote
Old 06-04-2024, 06:22 AM   #10
Bill
Site Team
 
Bill's Avatar
 
Join Date: Feb 2003
Location: The mountains of Scottsdale, AZ, and the beaches of Maine
Posts: 10,216
Default

I have to agree with the conclusions above. It seems that the battery is not being charged AT ALL, and is struggling to provide a bit of residual energy from the last time it was properly charged. The fact that some 12-volt appliances (panel on the sink apron, etc) work A LITTLE BIT when the battery is connected, and the trailer is unplugged from shore power, says that the battery fuse is OK. The fact that no 12-volt appliances work AT ALL when the battery is disconnected points to a charger problem. As has been mentioned, all the 12-volt appliances should work perfectly, powered by the charger, even with the battery disconnected. The fact that they don't work at all points to a charger failure.

I think you can replace the charger portion of the WFCO converter for about $100 at Amazon, if you are willing to do a small amount of work to install it. You don't have to buy an entire converter-plus-installation from a RV dealer. For example, check out https://www.bestconverter.com/Replac...955_c_196.html

Bill
__________________
2020 2720QS (aka 2720SL)
2014 Ford F-150 4WD 5.0L
Bill's Tech Stuff album
Bill is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Battery Health & Charging Options SirDrake Electrical 17 09-19-2022 01:45 PM
DayTripper Charging and Battery Box flexibility Peterbug Electrical 1 08-11-2019 01:08 PM
Battery Charging Settings BradS7535 Electrical 12 12-05-2016 02:50 PM
Battery charging Bill TrailManor Technical Library 0 09-30-2004 12:40 PM


All times are GMT -6. The time now is 04:33 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 2022 Trailmanor Owners Page.