Help IDing interior part names for replacement

[Diamond_D]

I have a few parts that were damaged by the prior owner, would like to replace them this year but I'm not sure of how to refer to them when requesting a replacement. I sent pics and tried to describe the part that spans behind the dinette to the wall, but was instead sent the parts create a bag seal replacement across the roof, then never got a response to follow up emails and calls... but I hear maybe factory communication is a bit improved since last year?

Anyway, first part is this little divider on the side of the dinette, next to the entry door area. Not sure how that is attached, or if there's a good way to repair?

Second 2 pics are the canvas/velcro seal that goes from behind the dinette seats to the wall, closing the air gap there.

This is a 2417kb from 2015, in case that helps. Thank you for any details you can provide, I appreciate it!

[Shane826]

You might be SOL on the flaps as that’s no longer a production model.

[Kidkraz]

I would pull that end piece off, remove the fabric and any foam if there is any. Lay the board on top of either luan or a thin stiff board trace it and cut it with a jig saw. If the fabric is still useable recover and reinstall. I'd measure the length of those sidewall flap seals and email the factory to see if they can shorten a seal that would go on a 2518 TM. The seals should be the same, but just differant length for each specific camper.

[Shane826]

If they are willing to make those vinyl flaps you might even be better off just sending them the old ones to use as a pattern.

[Kmikesell]

They are in order:
*Thingamajig
*Doohicky
*Whatchamacallit