I will be bringing a prototype sheetmetal plumbing protection (from blowouts) shield to the West Coast Rally and will appreciate some discussion/thoiughts around this thing. (I have the metal part but the TM won't be home until tomorrow to verify if this design really works or needs a bit of tweaking.) My shield is similar to that shown in ShrimpBurrito's post at
http://www.trailmanorowners.com/foru...ead.php?t=7972; but just to be clear, I had this made up several months ago and am just getting around to seeing if it really fits. I had hoped to have it all worked out by the rally and ready to show-off,
but life got in the way.
Dave's photo of an older TM show a bit different floor support system than mine; the anchor points that I have chosen to use may or may not be available on all models...if this all works out images will follow later this week or early next.
Looking forward to Petaluma,
Mark