TrailManor Owner's Forum  

Go Back   TrailManor Owner's Forum > TrailManor Owners Community > General TrailManor Topics
Register FAQ Members List Calendar

Reply
 
Thread Tools Display Modes
Old 07-28-2014, 12:01 PM   #1
RottieMom
TrailManor Master
 
RottieMom's Avatar
 
Join Date: Jun 2014
Location: Tijeras, NM
Posts: 262
Default Lessons learned from first trip with TM

OK, took TM on first trip this past week. I learned some things the hard way. First night, I was at a dog event in Rist Canyon (Colorado) which is close to Fort Collings. Drove up from Albuquerque area. The event was held in a big field... no level ground. But, I figured no problem, I've read up on how to the level the trailer, side to side and front to back.

First thing I learned (for me anyway) is do not have the TM where it is higher than the TV when you back it up into where you're going to setup (might not be such a great idea to have the reverse either, where the TV is higher than the TM). Anyway, I had the tongue support on a wood block and the TM unhitched (and wheels chocked), and went to get into my truck to pull it forward out of the way, and heard a BAM. Went back to look at trailer and the tongue support had flipped the wood block over and the tongue landed on the ball mount... but not on the ball. I figured since it was resting on the ball mount I could raise the tongue support, get the wood block back under it and then would be ok. That worked, got it situated again and then pulled truck out of the way. You would think that since I'd already had the wood block flip over once, I would have oriented it differently so that the length of the block would have been up and down the grade of the land (block was about 4" x 6" x 12"), but no... I put it under the tongue the same way I had as the first time. So, guess what happened? Wood block flipped over again and tongue support slid off and landed in soft ground... buried itself a good inch or more. Now I'm thinking... holy cow... what do I do now to raise this thing? Scissor jacks... I used the scissor jacks to lift up the front of the TM and got the tongue support out of the ground and this time put the wood block oriented the right way.

I've decided scissor jacks are a great thing. Got the TM leveled and everything else setup, then fed the dogs and crashed. Was exhausted after the drive up from ABQ and the stress from getting the TM setup by myself.

Next day, after the dog event was over, I had to pack up and move to a State Park where I planned to stay for a couple nights and see how things worked being hooked up to electricity. I'll say this, I was much more aware of the level of the trailer this time (and it was easier as I was parking on asphalt). Weather looked bad next morning, so I decided to pack up and head home a day early.

Got home and was really tired from long trip and got in too big of a hurry backing my TM in thru the gate of my driveway. It's a little tricky because I need to come in at an angle and then back into the garage. I have a light pole and intercom by the gate and I was watching that and cut it a little too much and instead of being at an angle I had the trailer backing in too straight and failed to negotiate the retaining wall in front of my house. While I was backing up I heard a BAM and it felt like I hit something which didn't make sense because there was nothing behind the trailer. I got out to check it out and saw that one wheel was over my retaining wall and the axel was sitting on the wall... So, what did I do? Called my neighbors

Thank goodness for great neighbors! One of guys said, no problem, we'll jack it up and put stuff under the wheel and you'll drive it out... and, I'm like WHAT!!?? So, he said chill out... this is guy stuff... we've got this. Normally, a chauvinist attitude might bother me, but not this time... I was really, really glad that they did know what they were doing and sure enough after 2 hours of jacking up the TM and putting blocks under the wheel, I was able to drive it out. Amazingly enough, there was no damage to the TM. The axel and the stairs are what landed on the wall and nothing else was touched underneath. Of course, I've got to have the wall repaired, but big deal, all things considered. (See attached picture of my neighbors getting me out of this jam.)

So... what did I learn... 1) where you park matters, 2) get a better wood block for the tongue support (am building one that has a wide base), 3) do NOT get in a hurry no matter what, and 4) try to live where you have great neighbors in case you really screw up.
Attached Thumbnails
Click image for larger version

Name:	Backing up Oops reduced size.JPG
Views:	1389
Size:	147.4 KB
ID:	10386  
__________________
Cindy & the Pups (Xena & Ozzy)

[SIGPIC][/SIGPIC]

2013 TM 2720SL
2011 Dodge Ram 1500 SLT 4x4 Hemi 5.7
RottieMom is offline   Reply With Quote
Old 07-28-2014, 12:38 PM   #2
Padgett
TrailManor Master
 
Padgett's Avatar
 
Join Date: Apr 2014
Location: Orlando
Posts: 2,796
Default

a) do the levelling jacks swivel ? Mine ('06) point out the side.
b) chock wheels before removing TV.
c) Anything odd happens, stop where you are and find out what it was.
__________________
Looking for a 24/17 in or near Florida.
Padgett is offline   Reply With Quote
Old 07-28-2014, 12:50 PM   #3
rvcycleguy
TrailManor Master
 
Join Date: Oct 2011
Location: New Braunfels, Texas
Posts: 919
Default

Quote:
Originally Posted by Padgett View Post
a) do the levelling jacks swivel ? Mine ('06) point out the side.
b) chock wheels before removing TV.
c) Anything odd happens, stop where you are and find out what it was.
a. Guy is using a scissor jack not mounted to the TM.
b. the OP states in the post the wheels were chocked.
__________________
rvcycleguy

TM-2002 3124KB
TV-2003 Toyota Tundra V8 4.7L. Fact. Tow Pkg, air bags
2006 Suzuki Boulevard C50c Motorcycle- crashed- parted out
1956 Royal Enfield Bullet 500 Motorcycle-sold
2006 Harley Road King
rvcycleguy is offline   Reply With Quote
Old 07-28-2014, 01:12 PM   #4
Padgett
TrailManor Master
 
Padgett's Avatar
 
Join Date: Apr 2014
Location: Orlando
Posts: 2,796
Default

Also need to check the inside of the tire that dropped for cuts.
__________________
Looking for a 24/17 in or near Florida.
Padgett is offline   Reply With Quote
Old 07-28-2014, 01:47 PM   #5
clan_salmons
Senior Member
 
clan_salmons's Avatar
 
Join Date: Sep 2011
Location: Lynchburg, VA
Posts: 107
Default

We use a tongue jack stand. Works great and can handle some of that unlevel ground.

http://www.amazon.com/gp/aw/d/B000BG...&robot_redir=1

Our local RV store was selling it for the amazon price.
__________________
TM 2008 3023
TV 2009 Porsche Cayenne 3.6L V6

[SIGPIC][/SIGPIC]
clan_salmons is offline   Reply With Quote
Old 07-28-2014, 01:49 PM   #6
RottieMom
TrailManor Master
 
RottieMom's Avatar
 
Join Date: Jun 2014
Location: Tijeras, NM
Posts: 262
Default

Yep, in the photo one of the guys is actually using a scissor jack underneath the TM scissor jack. We couldn't get the TM scissor jack down because the wall was blocking it. Wheels were chocked in my earlier mishaps, but not in the retaining wall mishap. TM was still hooked up to TV and park brake set.
__________________
Cindy & the Pups (Xena & Ozzy)

[SIGPIC][/SIGPIC]

2013 TM 2720SL
2011 Dodge Ram 1500 SLT 4x4 Hemi 5.7
RottieMom is offline   Reply With Quote
Old 07-28-2014, 01:52 PM   #7
wilson
Member
 
wilson's Avatar
 
Join Date: Jul 2014
Location: St George, Louisiana
Posts: 28
Default

It might be a good idea to also have the axle checked for possible damage. http://www.trailmanorowners.com/foru...ight=Bent+axle
__________________
[SIGPIC][/SIGPIC]

Harvey & Elaine Wilson
'05 2720SL
'01 Tahoe LT
wilson is offline   Reply With Quote
Old 07-28-2014, 01:52 PM   #8
RottieMom
TrailManor Master
 
RottieMom's Avatar
 
Join Date: Jun 2014
Location: Tijeras, NM
Posts: 262
Default

Thx Clan... I'll look into the tongue jack stand thing.
__________________
Cindy & the Pups (Xena & Ozzy)

[SIGPIC][/SIGPIC]

2013 TM 2720SL
2011 Dodge Ram 1500 SLT 4x4 Hemi 5.7
RottieMom is offline   Reply With Quote
Old 07-28-2014, 02:01 PM   #9
RottieMom
TrailManor Master
 
RottieMom's Avatar
 
Join Date: Jun 2014
Location: Tijeras, NM
Posts: 262
Default

Thx Wilson... I'll look into having the axle checked out. Just looking at it, it looks ok, but there might be something I can't see.
__________________
Cindy & the Pups (Xena & Ozzy)

[SIGPIC][/SIGPIC]

2013 TM 2720SL
2011 Dodge Ram 1500 SLT 4x4 Hemi 5.7
RottieMom is offline   Reply With Quote
Old 07-28-2014, 03:41 PM   #10
moaboy
Guest
 
Posts: n/a
Default

Hate to say it, but it looks like some of the guys in the photo are actually enjoying themselves...great neighbors indeed.
  Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
First trip with our 3124KB - Lessons Learned Pilotmickey TrailManor Pictures 6 06-13-2013 08:09 AM
First road trip with my TM Drews60 Camping Stories 14 07-05-2012 07:23 PM
Maiden TM Camping Trip A Success Steppy Camping Stories 15 06-30-2011 08:35 AM
1st trip with TM this past weekend boater454 Camping Stories 1 08-30-2010 08:40 AM
Summary Of Extended Trip Out West Philip Camping Stories 11 08-10-2010 03:42 PM


All times are GMT -6. The time now is 02:10 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 2022 Trailmanor Owners Page.